| 祁明辉,易锬,莫琪,邓景纯,张金兰,黄丽婕,黄崇杏,刘杨,赵辉,王双飞.硫酸水解辅助高压均质法制备小麦秸秆纳米纤维素[J].中国造纸学报,2020,35(3):1-8 |
二维码（扫一下试试看！） |
| 硫酸水解辅助高压均质法制备小麦秸秆纳米纤维素 |
| Preparation of Wheat Straw Nanocellulose by Acid Hydrolysis Assisted High Pressure Homogenization |
| 投稿时间：2020-01-18 |
| DOI：10.11981/j.issn.1000-6842.2020.03.01 |
| 中文关键词: 小麦秸秆 纳米纤维素 纳米纤维素晶须 硫酸水解 高压均质法 |
| Key Words:wheat straw nanocellulose nanocellulose whisker sulfuric acid hydrolysis high pressure homogenization |
| 基金项目:广西清洁化制浆造纸与污染控制重点实验室开放基金（ZR201806-6）；南宁市科学研究与技术开发计划项目（20195215）；广西科技计划项目（桂科AB18221126）；广西大学“大学生创新创业训练计划”（201810593047）。 |
|
| 摘要点击次数: 2778 |
| 全文下载次数: 993 |
| 中文摘要: |
| 以小麦秸秆纤维素为原料，通过硫酸水解辅助高压均质的方法，分层制备小麦秸秆纳米纤维素（CNC）；分别采用马尔文纳米粒度分析仪、透射电子显微镜、原子力显微镜、傅里叶变换红外光谱仪、X射线衍射仪和热重分析仪对分层制备的小麦秸秆CNC进行表征分析。结果表明，经硫酸水解预处理、离心收集得到的上层清液纳米纤维素（CNC-SL）为纳米纤维素晶须，与原料相比，其结晶度由48.61%提高至71.87%；硫酸水解预处理、离心收集的残余纤维固体（CNC-S）经8次均质处理制备的纳米纤维素（CNC-SP），其粒径分布在100~200 nm，直径约为15 nm，为高结晶度的短棒状纳米纤维素晶须，晶型为Iβ型。与原料相比，CNC-SL和CNC-SP的热稳定性均下降。与硫酸水解法制备CNC相比，硫酸水解辅助高压均质法制备的CNC得率较高；与机械均质化方法相比，此方法所需均质次数明显减少。 |
| Abstract: |
| Nanocellulose of wheat straw was prepared in layers by means of acidolysis assisted high pressure homogenization. Subsequently， the layered wheat straw nanocellulose was characterized by Marvin nano-particle analyzer， transmission electron microscope， atomic force microscope， infrared spectrum， X-ray diffractometer and thermal stability analyzer. The nanocellulose prepared from the supernatant was the nanocellulose whisker， and the crystallinity increased from 48.61% of the wheat straw materials to 71.87%. The residual fiber solids of wheat straw after cellulose acidolysis were homogenized for 8 times under the condition of 150 MPa to obtain nanocellulose. The resulted particle size distribution was 100~200 nm， the diameter was about 15 nm， and the same nanocellulose whiskers with high crystallinity （Iβ） were obtained. The thermal stability of both nanocellulose wiskers decreased compared with the raw materials. The yield of nanocellulose prepared by this method was higher than that by the method of complete sulfuric acid hydrolysis， and the number of homogenization times was obviously reduced compared with that of complete mechanical homogenization. |
| 查看全文 查看/发表评论 下载PDF阅读器 HTML |
