罗显星,王习文.基于NaOH-Urea预处理的微纤化纤维素制备研究[J].中国造纸学报,2018,33(2):1-5 本文二维码信息
二维码(扫一下试试看!)
基于NaOH-Urea预处理的微纤化纤维素制备研究
Preparation of Microfibrillated Cellulose Based on NaOH-Urea Pretreatment
  
DOI:10.11981/j.issn.1000-6842.2018.02.1
中文关键词:  氢氧化钠-尿素溶液  预处理  微纤化纤维素
Key Words:NaOH-Urea solution  pretreatment  microfibrillated cellulose
基金项目:国家自然科学基金(31470608);中央高校基本业务费(201522117)。
作者单位
罗显星 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
王习文* 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
摘要点击次数: 4761
全文下载次数: 1136
中文摘要:
      为开发高效制备微纤化纤维素的方法,探讨了基于氢氧化钠-尿素(NaOH-Urea)混合溶液对玉米芯微晶纤维素进行预处理后采用机械法处理的微纤化纤维素制备工艺。采用傅里叶变换红外光谱仪(FT-IR)、X射线衍射仪(XRD)、热重分析仪(TG)、场发射扫描电镜(FESEM)对制备的微纤化纤维素化学结构、结晶度、热稳定性及微观形貌进行表征。结果表明,制备的微纤化纤维素为纤维素Ⅰ型;微纤化纤维素的结晶度为604%,得率高达78%;微纤化纤维素结晶度较玉米芯微晶纤维素有所提高;制备的微纤化纤维素表现出优良的热稳定性,热降解温度达238℃;微纤化纤维素呈棒状,直径为5~20 nm,长度大于200 nm。
Abstract:
      In order to develop an efficient method for preparing microfibrillated cellulose (MFC), the microcrystalline cellulose (MCC) of corncob powder was pretreated by NaOH-Urea solution, and follwed by mechanical treatment to prepare MFC. The chemical structure, crystallinity, thermostability and microtopography of MFC were characterized by fourier transform infrared spectroscopy (FT-IR), X-ray diffraction (XRD), thermogravimetric (TG), and field emission scanning electron microscopy (FESEM). The results showed that the prepared MFC was cellulose Ⅰ type with the yield up to 78%. The crystallinity of MFC was 604%, and increased compared with the MCC. MFC showed excellent thermal stability and the thermal degradation temperature was up to 238℃. MFC was long rod-like with the diameter of 5~20 nm, the length was longer than 200 nm.
查看全文  查看/发表评论  下载PDF阅读器  HTML

分享按钮