林凌蕊,杨洁,曲一飞,孟峰,杨文恒,韩冲,杨益琴,戴红旗.基于资源化回用的OCC废纸浆二次淀粉的理化特性研究[J].中国造纸学报,2020,35(1):47-53 本文二维码信息
二维码(扫一下试试看!)
基于资源化回用的OCC废纸浆二次淀粉的理化特性研究
Physicochemical Characteristics of Secondary Starch from OCC Pulp
投稿时间:2019-07-31  
DOI:10.11981/j.issn.1000-6842.2020.01.47
中文关键词:  OCC废纸浆  二次淀粉  理化特性  资源化回用
Key Words:
基金项目:江苏省科技计划项目(BE2018129);国家自然科学基金项目(31770417)。
作者单位邮编
林凌蕊 南京林业大学江苏省制浆造纸科学与技术重点实验室江苏南京210037 210037
杨洁 南京林业大学江苏省制浆造纸科学与技术重点实验室江苏南京210037 210037
曲一飞 南京林业大学江苏省制浆造纸科学与技术重点实验室江苏南京210037 210037
孟峰 玖龙纸业 (太仓)有限公司江苏太仓215434 215434
杨文恒 玖龙纸业 (太仓)有限公司江苏太仓215434 215434
韩冲 玖龙纸业 (太仓)有限公司江苏太仓215434 215434
杨益琴 南京林业大学江苏省制浆造纸科学与技术重点实验室江苏南京210037 210037
戴红旗 南京林业大学江苏省制浆造纸科学与技术重点实验室江苏南京210037 210037
摘要点击次数: 3174
全文下载次数: 1748
中文摘要:
      采用纸张表面施胶-干燥-溶解的基本工艺步骤,模拟制备废旧箱纸板(OCC)废纸浆二次淀粉,分析了制浆过程中OCC废纸浆进入水相后二次淀粉的理化特性及过氧化氢(H2O2)离子化改性二次淀粉的留着性能。结果表明,当溶解条件为温度90℃、溶解时间30 min、转速1500 r/min时,二次淀粉几乎完全溶解;二次淀粉黏均分子质量由0.4×105 g/mol降为0.3×105 g/mol;热稳定性能下降,最大热分解温度由316.5℃降至303.6℃;红外分析表明没有新的官能团生成;将H2O2离子化改性的二次淀粉回用于造纸湿部,取代度(DS)0.15的改性二次淀粉在纤维上的留着率可达约48.0%,并提高了纸张物理性能。
Abstract:
      The secondary starch in the simulant recycled OCC waste paper was obtained in a sequence of surface sizing with starch, drying and dissolving. The physicochemical characteristics of secondary starch from re-pulping of simulant OCC waste paper and its retention rate in papers after modification were evaluated. Results showed that the starch almost completely dissolved when the resolving conditions were temperature of 90℃, dissolving time of 30 min and rotate speed of 1500 r/min. The molecular weight of secondary starch decreased from 0.4×105 g/mol to 0.3×105 g/mol, and its thermal stability decreased, with the maximum thermal decomposition temperature decreasing from 316.5℃ to 303.6℃. The secondary starch after ionization modification by hydrogen peroxide was added in the wet-end section, results showed that the retention rate of secondary starch reached ~48% when the substitution degree (DS) is 0.15, and the strength properties of the paper were also enhanced.
查看全文  查看/发表评论  下载PDF阅读器  HTML

分享按钮